Lattice Structure for Improving Cooling Uniformity in HPDC Mould Corners

Conformal cooling channels have demonstrated significant advantages for cast parts and 3D-printed moulds in the high-pressure die casting (HPDC) process. However, the complex geometry of moulds, characterised by small intrusions, sharp corners, and fins, often results in nonuniform cooling in certain regions, leading to overcooling or overheating. This study proposes integrating lattice structures within specific regions of 3D-printed moulds or inserts as an additional control parameter to enhance cooling uniformity by increasing thermal resistance in targeted areas. A validated three-dimensional Computational Fluid Dynamics (CFD) model was employed to incorporate three types of lattice structures, aiming to limit local heat flux in overcooled areas. The model specifically addresses the cooling of an aluminium alloy profile with 90-degree-angled corners, using H13 steel mould properties. The results indicate that implementing a lattice structure as a sleeve around the cooling pipe at the corner two sides improved temperature uniformity by over 42%. However, this increased thermal resistance also led to a 16 °C rise in corner temperature. These findings suggest that implementing lattice structures in the mould can improve cooling uniformity. However, they should be positioned away from the thickest regions of the mould to avoid increasing the modelling time.<p></p>